WIN-911

In previous versions of Win-911, Windows would pop-up and focus on the alarm viewer page when an alarm came in, no need to change windows manually to get to the alarm monitor page.

Can you add the ability to filter on Alarm State in the Montior tab in Control Center? In previous versions of 911, Inactive UnkAk alarms didn't show in the alarm viewer, but in 2024, they are showing along with the active alarms.

Given a specific datetime, display a list of Connections grouped by Contact where each connection is on duty for specified time. Extend to timespan with options for full or partial range matches.

With a redundant OPC-DA node licence, following an OPC server switchover, all the active alarms are being resent by Win911. This should not occur, the standy OPC node should be synched with the active Node licence and should be able to see that th...

Factorytalk Optix is Rockwell's newest visualization software. It would be amazing if win 911 worked with it, similar to the way out works with FactoryTalk alarms and events

It would be nice if Win911 was able to failover to a redundant modem in case of failure for a Win911 system without a redundant system.

Interesting issue occurs when both primary and backup WIN-911 servers are configured in the Control Center with History/Time both enabled. Tried going over this issue with support, but there was nothing they could do. The Timeline (when Auto Updat...

Use the value or alarm status of a specific tag in the source system to route other alarms. E.g. a decision block in the Advanced Notification Policies that can read the value or alarm state of a specific iFIX tag.

Receiving a notification that connectivity has been restored would be helpful. Your servers could ping ours every minute or so until connectivity has been restored and a notification could be sent. OR, WIN-911 on our server could try pinging (comm...