Skip to Main Content
SmartSights Feature Requests


Showing 169 of 169

Add filter to for Alarm State in Control Center

Can you add the ability to filter on Alarm State in the Montior tab in Control Center? In previous versions of 911, Inactive UnkAk alarms didn't show in the alarm viewer, but in 2024, they are showing along with the active alarms.
9 days ago in WIN-911 0

Allow Callout Lists created for Workflows to be accessed via Operator Workspace

No description provided
21 days ago in WIN-911 0

Schedule Query

Given a specific datetime, display a list of Connections grouped by Contact where each connection is on duty for specified time. Extend to timespan with options for full or partial range matches.
29 days ago in WIN-911 0

Hot backup OPC-DA node licence

With a redundant OPC-DA node licence, following an OPC server switchover, all the active alarms are being resent by Win911. This should not occur, the standy OPC node should be synched with the active Node licence and should be able to see that th...
about 1 month ago in WIN-911 0


Factorytalk Optix is Rockwell's newest visualization software. It would be amazing if win 911 worked with it, similar to the way out works with FactoryTalk alarms and events
about 1 month ago in WIN-911 0

public holidays management

One customer asks for the possibility to manage such a public holidays calendar to be able to perform some action (like report generation) only in working days or public holidays. It should be also possible to manual add public holidays, according...
about 2 months ago in XLReporter 0

Ability for Win911 to switch modems in case of failure

It would be nice if Win911 was able to failover to a redundant modem in case of failure for a Win911 system without a redundant system.
about 2 months ago in WIN-911 0

Allow Voice to Acknowledge Multiple Alarms

In some systems an event can generate multiple alarms which can take a long time to listen and acknowledge individually. It would be helpful if there was an option to send "acknowledge all" from phone interface.
over 2 years ago in WIN-911 3 Planned

Control Center Timeline Automatically Filtering Based on Active/Standby Status

Interesting issue occurs when both primary and backup WIN-911 servers are configured in the Control Center with History/Time both enabled. Tried going over this issue with support, but there was nothing they could do. The Timeline (when Auto Updat...
3 months ago in WIN-911 1

Alarm routing based on the value or status of another tag

Use the value or alarm status of a specific tag in the source system to route other alarms. E.g. a decision block in the Advanced Notification Policies that can read the value or alarm state of a specific iFIX tag.
3 months ago in WIN-911 0